P2AB9 BMW Fault Code

Description:

Catalytic converters must be warm before they can work properly. On a cold start the PCM provides a rich mixture to keep the cold engine running.
All that extra fuel goes into the catalytic converter. But the exhaust isn't very hot, because, ah, the engine is pretty cold. GM has employed several strategies to fire up the catalytic converter quicker and reduce cold start emissions. One way is to use a secondary air pump that pumps outside air directly into the catalytic converter.

P2AB9 Code Symptoms :

When you turn on the ignition, the Service Engine Soon or Check Engine P2AB9 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the P2AB9!

Diagnosis And Repairing P2AB9

P2AB9 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix P2AB9 code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• EVAP canister or fuel tank leaks
• Faulty starter motor
• Variable Valve Timing (VVT) circuit is open or shorted

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.